|
|
Home > headrest-monitor-installation
| | |
|
|
Cut In Headrest Monitor Installation - Learn How to Install Headrest Monitors With or Without Integrated DVD Players in Any Vehicle
Qualitymobilevideo.com has put together a detailed set of resources to help consumers install all of the latest dvd headrest monitors in their vehicles. We have developed printable instructions and how-to videos to better explain the headrest monitor installation process.
We have put together a set of resources that will help you to install your headrest video system. We have also partnered with InstallerNet to offer nationwide prepaid installation services if you feel that self installation is too much for you.
Make sure to use our web forum where you can post your projects and ask questions to further help you through your installation.
|
Table : Click on image for a high resolution image
Installing cut in headrest monitors in a Chevy Suburban
-
-
To remove you factory headrests you will need to use a allen wrench or right angle pick. Simply insert the allen wrench or pick into the hole on the side of the headrest post and pull the headrest up.
-
-
Use the trim ring or cutting template to properly place your headrest monitor on the headrest. Makes sure to have at least 3/8" of an inch from each corner.
-
-
After determining your placement with the template, start to cut you headrests from opposite corner to opposite corner. By cutting this way you will create an X pattern. Make sure to use a straight edge and start your cut 3/8" of an inch inside of the corner.
-
-
Once you have cut your X pattern you will need to verify that you have 1/4" to 3/8" from each corner uncut.
-
-
You will need to determine the amount of foam you will need to remove in order to have the headrest shroud mount flush to the headrest surface. For most monitors that is usually 1" of foam that needs to be removed. Begin cutting the outline of the monitor.
-
-
Carefully pull the headrest material back to cut the foam out of the headrest.Cut in small step and check against the headrest shroud. It better to make a bunch of small cuts instead of one deep cut.
-
-
Double check the depth of cut by inserting the headrest bucket into the headrest to determine whether or not you have removed enough foam. As a rule of thumb, we cut and extra 1/4" of foam out in order to have the headrest bucket look slightly recessed in the headrest.
-
-
Run your power wires through the seat an install you headrest monitors with adhesive or screws.
| |
| | |
|
| Testimonials |
|
|
| Review Date: 07/16/2011 |
| Reviewer Name: djweber |
| Your sales agents were very helpfull. |
| |
| Review Date: 07/16/2011 |
| Reviewer Name: Nyyankees882 |
| I have had nothing but good transaction with quality mobile video so far. Very nice to have that feeling, as to most sites you are just a number for them. Thanks for the great service....so far. |
| |
| Review Date: 07/17/2011 |
| Reviewer Name: Ahambright |
| Great prices, great products! |
| |
| Review Date: 08/24/2011 |
| Reviewer Name: Eric.timme |
| The site is very easy to navigate. Everything about my purchase was easy. |
| |
| Review Date: 08/24/2011 |
| Reviewer Name: Olive2112 |
| Easy and convienant, would buy from this site again. |
| |
| Review Date: 08/31/2011 |
| Reviewer Name: Akmuller2 |
| Good Supplier. |
| |
|
|