Replace Factory Radio - Radio Interfaces
When replacing your factory radio with an aftermarket radio you will want to not cut any of the factory wiring. Radio replacement harnesses make this very easy with a simple plug and play connector so you don't have to splice power, ground and speaker connections to the aftermarket radio connector that is included with your new aftermarket radio.
Car radio replacement radio interfaces allow you to remove your factory radio and install a new factory radio while retaining all of the factory features.
Car radio replacement radio interfaces allow you to remove your factory radio and install a new factory radio while retaining all of the factory features.
Onstar adaptors - Onstar adaptors allow you to remove your factory radio and install a new factory radio while retaining all of the factoyr Onstar features.
Shop By
-
Metra AFSI-01 Ford SYNC Retention Interface with Navigation Output Wires with OLED display$11.99Out of stock- Complete car stereo integration harness for Non-Amplified audio systems
- Provides 12 volt 10 amp car accessory
- Provides RAP (Retained Accessory Power)
- High level speaker inputs for connections to factory speakers
- Provides NAV outputs (parking brake, reverse, mute, V.S.S.)
- Retains OEM Bluetooth system
-
Metra NIRD-01 Dash Kit Turbokit Nissan Maxima and Sentra 2007-2008 Vehicles Axxess OEM Information Display and Bluetooth Retention Interface$16.99Out of stockMetra NIRD-01 Dash Kit Turbokit Nissan Maxima and Sentra 2007-2008 Vehicles Axxess OEM Information Display and Bluetooth Retention Interface Learn More -
Axxess AFDI-5V 12 Volt To 5 Volt Step Down Regulator Used In Amplified Ford Systems$18.99- Used to install and aftermarket car stereo with factory Ford and Lincoln Amplified audio systems
- Steps 12 volt output to 5 volts to prevent audible pop
- Simple three wire connection
- Can be used as a regulated power supply for USB power
-
Metra CHRY-AMP-01 2005-07 Add An Amp To Existing Amp System$22.99Metra CHRY-AMP-01 2005-07 Add An Amp To Existing Amp System Learn More -
idataLink Maestro HRN-RR-SU1 Radio Replacement and Steering Wheel Interface Harness for 2008 - 2015 Subaru Vehicles$36.99- Fits select 2008 - 2015 Subaru Vehicles
- Plug-and-Play T-harness for ADS-MRR Interface
- Install and aftermarket car stereo receiver and retain all OEM features and audio system
- Provides inputs and output to aftermarket car stereo receiver (Speaker, Power/Ground, Illumination, and Navigation)
- Displays engine performance data on touchscreen with select Alpine, JVC, Kenwood and Pioneer receivers
-
idataLink Maestro HRN-HRR-CH1 Radio Replacement and Steering Wheel Interface Harness for 2007 - 2020 Chrysler / Dodge / Jeep / Mitsubishi / RAM / Volkswagen$39.99- Fits select 2007 - 2020 Dodge and Chrysler Vehicles
- Plug-and-Play T-harness for ADS-MRR Interface
- Install and aftermarket car stereo receiver and retain all OEM features and audio system
- Provides inputs and output to aftermarket car stereo receiver (Speaker, Power/Ground, Illumination, and Navigation)
- Displays engine performance data on touchscreen with select Alpine, JVC, Kenwood and Pioneer receivers
-
Pac LCGM24 Radio Replacement Interface for Select Nonamplified GM(R) Vehicles (Class II)$40.99- Pac LCGM24 Radio Replacement Interface for Select Nonamplified GM(R) Vehicles (Class II)
- Wiring Interfaces
-
Pac LCGM52 Radio Replacement Interface for 2016-2017 Select GM(R) Trucks with 7" Display$42.99- Pac LCGM52 Radio Replacement Interface for 2016-2017 Select GM(R) Trucks with 7" Display
- Wiring Interfaces
-
Pac LCGM29 Radio Replacement Interface for Select Nonamplified GM(R) Vehicles (29-Bit, 14 & 16 Pin)$43.99- Pac LCGM29 Radio Replacement Interface for Select Nonamplified GM(R) Vehicles (29-Bit, 14 & 16 Pin)
- Wiring Interfaces
-
Axxess AX-GMCL2 2000 - 2013 GM Radio Replacement Interface with navigation outputs$49.99- Fits 2000 - 2013 model years
- Complete General Motors radio replacement interface
- Provides connections for aftermarket stereo to factory audio system without cutting cables
- Retains RSE (rear seat entertainment)
- Retains SAT (satellite radio)
- USB updatable
-
Axxess AX-GMLAN29 2006 - and Up GM radio replacement LAN-BUS interface with steering wheel and navigation outputs$49.99Out of stock- Buick, Cadillac, Chevrolet, GMC, Hummer, Pontiac, Saturn, Suzuki complete radio replacement interface for plug-and-play installation of an aftermarket car radio
- Retains factory audio system and vehicle chimes
- Requires external steering wheel controller
- Provides NAV outputs (parking brake, reverse, and speed sense)
- Designed for non-amplified models, analog amplified models, or when bypassing a factory amp
-
Axxess AX-GMLAN11 2006 - 2012 GM radio replacement interface with navigation outputs$51.99- Chevrolet, Pontiac, Saturn complete radio replacement interface for plug-and-play installation of an aftermarket car radio
- Interface is designed for non-amplified models, amplified models, or when bypassing a factory amplifier
- Pre-wired for steering wheel control interface (Sold separately)
- Provides NAV outputs (parking brake, reverse, and speed sense)
-
Metra LC-GMRC-01 Economy Radio Replacement Data Bus interface with Chime Retention Speaker$54.99- Designed for GM vehicles with Class 2 data buss
- Provides accessory output for databus signals (12-volt 3-amp capable output)
- Retains R.A.P. (retained accessory power) while doors remain closed so you can continue to listen to the radio until doors open
- Interface is designed to be used with factory non-amplified systems or when removing the amplified audio system
- Does not retain OnStar
- Retains all factory warning chimes with built in speaker
-
Metra LC-GMRC-LAN-03 Economy Data Bus interface with Chime Retention Speaker$54.99- Provides accessory output for databus signals (12-volt 3-amp capable output)
- Retains R.A.P. (retained accessory power) while doors remain closed so you can continue to listen to the radio until doors open
- Interface is designed to be used with factory non-amplified systems or when removing the amplified audio system
- Retains all factory warning chimes with built in speaker
- Provides all connections to factory wiring and makes installing an aftermarket stereo very easy
- For select Chevrolet, Pontiac, and Saturn vehicles
-
Metra XSVI-1731-NAV 2016 - and Up Honda Civic Radio interface with Navigation outputs$55.99Out of stock- Provides all connections to factory wiring and makes installing an aftermarket stereo very easy in select 2016 - and Up Honda vehicles
- Provides accessory output
- Retains the factory backup camera
- Perfect for use with aftermarket navigation system as interface provides navigation system outputs (parking brake, reverse, mute, V.S.S.) from databus signals
Who Bought This Also Bought
My Wish List
Last Added Items
You have no items in your wish list.
Related Articles & Videos
How to install a car stereo
Watch our video and read our blog for step-by-step instructions documenting the installation of a aftermarket car stereo receiver.
QualityMobileVideo Blog
Car Stereo Wiring Guide
Watch our video and read our blog for the proper wiring colors and their definitions. We explain wire-by-wire what these connections do for the installation of an aftermarket car stereo receiver.
QualityMobileVideo Blog