Ram - Radio Interfaces
Car radio replacement radio interfaces allow you to remove your factory radio and install a new factory radio while retaining all of the factory features.
Onstar adaptors - Onstar adaptors allow you to remove your factory radio and install a new factory radio while retaining all of the factoyr Onstar features.
Shop By
- idataLink Maestro ACC-SP1 Factory chime replacement speaker$24.99
- Chime speaker for use with idataLink ADS-MRR Radio Replacement and Steering Wheel Interface module (Required and Sold Separately)
- Required for some vehicles with collision avoidance, lane departure or blind spot detection systems
- idataLink Maestro ACC-USB-RAM USB Media Hub replacement circuit board for 2013 - 2018 Dodge Ram Trucks$24.99
- Retain your center console media hub USB capabilities when you install an after-market radio
- Compatible with select 2013 - 2018 Dodge Ram Trucks
- Plug & Play Harness and requires no modification to factory wiring
- Metra LC-CHRC-01 Radio Replacement Data Bus interface with Chime Retention Speaker for 2013 and Up Dodge Ram pickup trucks$69.99
- Designed for 2013 and Up Dodge Ram pickup trucks
- Provides accessory output for databus signals (12-volt 3-amp capable output)
- Retains R.A.P. (retained accessory power) while doors remain closed so you can continue to listen to the radio until doors open
- Interface is designed to be used with factory non-amplified systems or when removing the amplified audio system
- Retains the 3.5mm AUX-IN jack
- Retains all factory warning chimes with built in speaker
- Axxess AX-CH5-SWC 2013 - and Up Chrysler radio replacement CAN-BUS interface with steering wheel and navigation outputs$139.99
- Chrysler, Dodge, Fiat, Jeep, RAM complete radio replacement interface for plug-and-play installation of an aftermarket car radio
- Retains factory audio system and vehicle chimes
- Retains steering wheel controls
- Provides NAV outputs (parking brake, reverse, and speed sense)
- Interface is designed for non-amplified models, or when bypassing a factory amplifier
- Axxess AX-CH013-SWC 2004 - and Up Chrysler radio replacement CAN-BUS interface with steering wheel and navigation outputs$139.99
- Chrysler, Jeep, Mitsubishi, and Volkswagen complete radio replacement interface for plug-and-play installation of an aftermarket car radio
- Interface is designed for non-amplified models, amplified models, or when bypassing a factory amplifier
- Built in steering wheel control interface
- Provides NAV outputs (parking brake, reverse, and speed sense)