Replace Factory Radio - Retain OEM USB Input - 2013 - Dodge - Radio Interfaces
When replacing your factory radio with an aftermarket radio you will want to not cut any of the factory wiring. Radio replacement harnesses make this very easy with a simple plug and play connector so you don't have to splice power, ground and speaker connections to the aftermarket radio connector that is included with your new aftermarket radio.
When replacing your factory radio with an aftermarket radio you will want to most likely retain your OEM USB port. Factory USB retention harnesses make this very easy with a simple plug and play connector so you don't have to splice power, ground and USB signals to USB connector that your new aftermarket radio can use.
Car radio replacement radio interfaces allow you to remove your factory radio and install a new factory radio while retaining all of the factory features.
When replacing your factory radio with an aftermarket radio you will want to most likely retain your OEM USB port. Factory USB retention harnesses make this very easy with a simple plug and play connector so you don't have to splice power, ground and USB signals to USB connector that your new aftermarket radio can use.
Car radio replacement radio interfaces allow you to remove your factory radio and install a new factory radio while retaining all of the factory features.
Onstar adaptors - Onstar adaptors allow you to remove your factory radio and install a new factory radio while retaining all of the factoyr Onstar features.
Shop By
- idataLink Maestro ACC-USB-RAM USB Media Hub replacement circuit board for 2013 - 2018 Dodge Ram Trucks$24.99
- Retain your center console media hub USB capabilities when you install an after-market radio
- Compatible with select 2013 - 2018 Dodge Ram Trucks
- Plug & Play Harness and requires no modification to factory wiring
- Metra LC-CHRC-01 Radio Replacement Data Bus interface with Chime Retention Speaker for 2013 and Up Dodge Ram pickup trucks$69.99
- Designed for 2013 and Up Dodge Ram pickup trucks
- Provides accessory output for databus signals (12-volt 3-amp capable output)
- Retains R.A.P. (retained accessory power) while doors remain closed so you can continue to listen to the radio until doors open
- Interface is designed to be used with factory non-amplified systems or when removing the amplified audio system
- Retains the 3.5mm AUX-IN jack
- Retains all factory warning chimes with built in speaker