Replace Factory Radio - Explorer - Ford Wiring Harness
When replacing your factory radio with an aftermarket radio you will want to not cut any of the factory wiring. Radio replacement harnesses make this very easy with a simple plug and play connector so you don't have to splice power, ground and speaker connections to the aftermarket radio connector that is included with your new aftermarket radio.
Shop By
- Metra 70-5517 Car Stereo Wiring Harness for 1998 - 2005 Ford / Lincoln / Mercury with Premium Sound Systems$20.99
- For 1998 - 2005 Ford / Lincoln / Mercury with Sound Systems Ford vehicles
- Used to install an aftermarket car stereo without cutting stock connections
- Designed for vehicles with premium audio systems and factory amplifier
- Uses high level speaker outputs for speaker connections
- Axxess AX-FD1 2007 - and Up Ford radio replacement CAN-BUS interface with navigation outputs$72.99Out of stock
- Ford complete radio replacement interface for plug-and-play installation of an aftermarket car radio
- Interface is designed for both non-amplified and amplified models (including SYNC/Sony/THX)
- Pre-wired for steering wheel control interface (Sold separately)
- Provides NAV outputs (parking brake, reverse, and speed sense)
- Retains the factory Subwoofer and Center channel
- Axxess AX-FD2-SWC 2011 - and Up Ford radio replacement interface with steering wheel and navigation outputs$139.99
- Ford complete radio replacement interface for plug-and-play installation of an aftermarket car radio
- Retains SYNC audio system and vehicle chimes
- Retains steering wheel controls
- Provides NAV outputs (parking brake, reverse, and speed sense)
- Retains the factory AUX-IN jack
- Interface is designed for non-amplified audio systems